MATERIALS: 
Seat — One-piece, 5/16" (8mm) thick, solidly fused plastic laminate with matte-finish melamine surfaces, ivory-colored face 
sheets, and black phenolic-resin core that are integrally bonded — cannot delaminate. Integral slots for water drainage. Secured 
to frame with stainless steel carriage bolts and acorn nuts.
Frame — 18-8 S, type-304, stainless steel with satin finish. 16-gauge (1.6mm), 1-1/4" (30mm) square tubing and 18 -gauge 
(1.2mm), 1" (25mm) diameter seamless tubing.
Mounting Flanges (2) — 18-8 S, type-304, 3/16" (5mm) thick stainless steel with satin finish. 3" (75mm) diameter with three 
mounting screw holes.
Baseplate — 18-8 S, type-304, heavy-gauge stainless steel.
Spring — 17-7, type-301, 24-gauge (0.6mm) stainless steel. Spot-welded to baseplate.
Guide Bracket — 18-8 S, type-304, 16-gauge (1.6mm) stainless steel with satin finish.
OpERATIOn:
Shower seat can be folded up against the wall when not in use. The spring at the top of baseplate locks seat into upright position 
until released by pulling the top of seat away from wall. Support system with guide bracket allows varying mounting heights 
and leaves floor clear for easier cleaning. Nonporous solid phenolic seat has slots to permit water to drain, does not splinter 
or require oiling, and will not support growth of bacteria. Slotless round-head carriage bolts and acorn nuts provide additional 
safety to user. Bobrick shower seats, when properly installed, have sufficient strength to support 500 lbs., (227 kg) complying 
with barrier-free accessibility guidelines (including ADAAG in the U.S.A.).
InSTALLATIOn:
Secure unit to wall at points indicated by an S, with the two mounting flanges located at top and the baseplate and guide bracket 
below. The bottom of support bracket must be positioned between the baseplate and guide bracket before they are secured to 
wall or partition. Mounting height of shower seat must comply with local building codes.
For stud walls, provide concealed backing to comply with local building codes and secure with #14 x 2-1/2" (6.3 x 65mm) 
stainless steel sheet-metal screws furnished by manufacturer.
For prefabricated shower stalls, provided adequate backing by the shower stall manufacturer.  Secure with #14 x 2-1/2" (6.3 x 
65mm) stainless steel mounting screws furnished by manufacturer.
For masonry walls, provide fiber plugs or expansion shields for use with furnished sheet-metal screws, or provide 1/4" (6mm) 
toggle bolts or expansion bolts. 
Caution: These shower seats are no stronger than the anchors and walls to which they are attached and, therefore, must be 
firmly secured in order to support the loads for which they are intended. Consult and comply with local building codes.